I think I'm going to build a subwoofer that uses an external amp in conjunction with a Richter Scale that I have laying around. Can you suggest an amp in the, oh, 200-300 watt range (8 ohm load)? -- or tell me where to look? I've googled, but I don't find much.
[I know this is a DIY forum, and I am not planning to build the amp, but I AM planning to build the subwoofer, so I hope that counts.]
[I know this is a DIY forum, and I am not planning to build the amp, but I AM planning to build the subwoofer, so I hope that counts.]
http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=300-806
...or find a decent used Adcom GFA-555II off of eBay and run it in bridged mode.
...or find a decent used Adcom GFA-555II off of eBay and run it in bridged mode.
250W/8R for only $159.95
About half the cost of the PE amp, and a better signal-to-noise ratio too.
http://www.apexjr.com/Apexsenior.htm
About half the cost of the PE amp, and a better signal-to-noise ratio too.
http://www.apexjr.com/Apexsenior.htm
this is on the upper-end of your price range, but its a great amp for the price. into an 8-ohm load bridged it will do around 250 watts.
http://www.partsexpress.com/pe/show...&St3=49638945&DS_ID=3&Product_ID=121162&DID=7
http://www.partsexpress.com/pe/show...&St3=49638945&DS_ID=3&Product_ID=121162&DID=7
- Status
- Not open for further replies.