Need a little help on this one. I am trying to build this simple mixer/preamp only without the tone and balance controls. My test circuit is also omitting the volume pots (I'll be using a digital IC for that once it is working.)
As noted in the schem I'm using an OPA2211 for the opamp in single supply setup for testing. I get +2.2v at B1 but nothing comes out when the amp is connected.
Any ideas?
As noted in the schem I'm using an OPA2211 for the opamp in single supply setup for testing. I get +2.2v at B1 but nothing comes out when the amp is connected.
Any ideas?
Attachments
Last edited:
ah, nevermind- figured it out. Even though the OPA2211 is supposed to be single supply it seems to need dual supply. Maybe only the OPA211 is single supply.
If anyone knows if I can omit the inverter buffer on the output that would be good to know. It looks like the volume pot I'm using might already have one:
QuickView - MAX5486 Stereo Volume Control with Pushbutton Interface
Great little preamp mixer but IMO ESP could use some work on joining schems better.
If anyone knows if I can omit the inverter buffer on the output that would be good to know. It looks like the volume pot I'm using might already have one:
QuickView - MAX5486 Stereo Volume Control with Pushbutton Interface
Great little preamp mixer but IMO ESP could use some work on joining schems better.
- Status
- Not open for further replies.