Hello forum 😀,
Hopefully i will get the attention of all modders here with significant experience. I own an Elemental Watson hybrid amp, and i wish to improve the sound quality if that is possible and to start i thought that will be good to swap all capacitors with some Elna Silmic. This is my first project so any help suggestion is very much appreciated. I uploaded some pictures of the capacitors and general layout of the amp at the bottom.
Regards,
Hopefully i will get the attention of all modders here with significant experience. I own an Elemental Watson hybrid amp, and i wish to improve the sound quality if that is possible and to start i thought that will be good to swap all capacitors with some Elna Silmic. This is my first project so any help suggestion is very much appreciated. I uploaded some pictures of the capacitors and general layout of the amp at the bottom.
Regards,
Attachments
Leave well enough alone! The Rubycon parts already in place are not junk.
Get and upload the schematic. The members can't make rational recommendations without that "road map".
Get and upload the schematic. The members can't make rational recommendations without that "road map".
if only, i use to have the schematics... this came build already is not a Diy product. And yes right Rubycon are not junk but there's only one out of 7 Rubycon parts in there all the rest are unknown brand.
I suggest you sell it on ebay, unaltered as non-munged amps are more valuebal,
and use the money to buy something you like better.
i actully like this, but i think that will sound better with a better PSU and perhaps better parts inside, it was build cheap on some parts and still is a great little unit, but thanks for the suggestion
- Status
- Not open for further replies.