Most people doing this at home (architects needing to cut hard plastics for models) guts a toaster. Keep the heat regulator to alter the effect.
Good idea!
Maria: that's a good suggestion. I have been useing a old iron up till now. Have also thought that I can make use od an old soldering station. In that way the heater element can be inserted directly into the body of the threaded rod to save a lot of space and much wasted heat while breathing life back into a broken station. Thanks again for the suggestion regards Moray James.
Maria: that's a good suggestion. I have been useing a old iron up till now. Have also thought that I can make use od an old soldering station. In that way the heater element can be inserted directly into the body of the threaded rod to save a lot of space and much wasted heat while breathing life back into a broken station. Thanks again for the suggestion regards Moray James.
This might be a little late...
http://www.acp-composites.com/acp-ta.htm
When you click "pricing" you won't see it here, but when you click "order"
there's a spot where they'll e-mail complete pricing....Big $$, though but if
its what you want...
Lucius
http://www.acp-composites.com/acp-ta.htm
When you click "pricing" you won't see it here, but when you click "order"
there's a spot where they'll e-mail complete pricing....Big $$, though but if
its what you want...
Lucius
Just for the halibut I googled "compufoil" listed in my prior post
and came up with this...
http://www.compufoil.com/product_fc.html
Holy flatfish!
Lucius
and came up with this...
http://www.compufoil.com/product_fc.html
Holy flatfish!
Lucius
- Status
- Not open for further replies.