Eagle question

[Ryssen]

Trying to do a junktion but getting this message:

The other junktions I could do without problems.
How do I select a net??

 

[Ryssen]

Some places it works to do a junktion och some it says do chose a net...

 

[Ryssen]

Got the boards today,they where smaller than I thought...

 

[Ryssen]

Trying to do a junktion but getting this message:



The other junktions I could do without problems.
How do I select a net??

I think it was a software problem that caused this.
I instaled Eagle again on top of the old one,and now the dialog box comes up asking sbout the net...So far so good...

 

[Ryssen]

I am testing the anode pcb on my KT 77 amp ,it is conected at the input tubes and gives it 3,1mA.So its working as it should.