Dynaudio Gemini clone but with 4 ohm woofers in series OK?

[NH7RO]

Just picked up my second pair of Dynaudio 15W75 4 ohm woofers on ebay so I can clone a Gemini (normally MTM with 2x 8 ohm 15W75s in parallel and 8 ohm D260 tweeter per side). Question is, will it be ok to wire the woofers in series and use whatever crossover design that is already out there for the 8 ohm drivers normally in parallel? Will I need to modify the crossover at all? Or would bi-amping this setup be the way around any problems with the woofers wired in series? --Jeff

 

[Wombat]

The Gemini has a very fine tuned switch. Every part you change wouldn´t
do good at all. I doubt you will get satisfiying results with redesigning
with different woofers.

Wombat