Is there any reason not to use dupont flashing tape as a gasket between the driver and the baffle. I have some left over.
thanks
thanks
Is the butyl side exposed? If so it may be very hard and messy to remove later.
This stuff works well for driver gasket:
https://www.amazon.com/dp/B08HV48WQV?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
This stuff works well for driver gasket:
https://www.amazon.com/dp/B08HV48WQV?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
thank you the paper side would be out not sure how long the paper will last though. I will pick up the weather stripping. I may want to eventually sell the drivers so I do not want to mess them up. I did want the driver to baffle to be air tight.
The wider tapes tend to wrinkle a bit too much at smaller diameters, so I tended to use 1/4” or 1/2” types.