I’ll post it tonight, I don’t have any shelf filters in the DSP, only the REW PEQ files and the cross over which I think is at 300 hz (?) 6db? Let me confirm. Thank you!
Hey Perry, when I load the Flex8 files this is the profile I get for the HF; EDIT:
I went back and loaded the 2x4HD files into the Template page, the HF profile is the second picture below. Maybe I'm not loading these correctly?
I went back and loaded the 2x4HD files into the Template page, the HF profile is the second picture below. Maybe I'm not loading these correctly?
Last edited:
Those are the old ones. They will work but are not the most recent. I’m still puzzled as to why in your measurements the tweeters go all the way down to 600Hz.
ok, sorry for the confusion. Where are the new ones? Maybe I'll just skip to those! The very flat response I was getting above was not using these files, it was my own PEQ
sorry for the multiple posts; this is the PEQ I came up with in my room for flat tweeter response, this is running with a high pass cross over at Basel 12db/octave, 300 Hz. This PEQ gives me the magenta line on axis freq response at .5M
It won't work to mix a minor part of what I did before with something else. You also don't want to mix part of the 2x4HD files with part of the Flex8 files. This latest curve with a 300Hz high pass crossover could blow your tweeters. Don't make up anything new to begin with. You need to start with the design exactly as is.
Here is the latest version, literally the config I'm using right this minute:
https://evo2.org/wp-content/uploads/2024/12/Bitches-Brew-FlexEight-11Dec2024.xml_.zip
It's also particular to my room, but that doesn't matter right now. Ignore channels 5 and 6.
Use this exact config for both LF and HF channels. Then measure nearfield on axis of the 15CXN88, both individually as well as together.
Here is the latest version, literally the config I'm using right this minute:
https://evo2.org/wp-content/uploads/2024/12/Bitches-Brew-FlexEight-11Dec2024.xml_.zip
It's also particular to my room, but that doesn't matter right now. Ignore channels 5 and 6.
Use this exact config for both LF and HF channels. Then measure nearfield on axis of the 15CXN88, both individually as well as together.
Perry, quick question... does the miniDSP Device Console allow real-time adjustment of filters in Normal Mode? (not asking about Advanced mode / biquads)
I read the manual but couldn't determine.....thx
I read the manual but couldn't determine.....thx