Hi there,
I know that this will probably be the nth thread about DIY DSPs based on AD chips. After countless of hours trawling the forum for a suitable design that fits a plateamp application I haven't found the one. So I'm taking the chance that someone could point me in the right direction before I bite the bullit and invest the time to design something from the ground up (or modify an existing design eg. FreeDSP classic or Catamaran).
Requirements are:
1 in (mono) 4 out analog balanced via pins for XLR (in) and JST connections (out).
15V power to run off AUX power supply from amp module
The usual features to take advantage of Sigma studio (USBi, monitoring, etc.)
Distortion < 0.005
Optimised layout for platemounting (perpendicular to faceplate)
Anyone with any ideas?
Thankful for any suggestions or leads 🙌
Cheers.
/M
I know that this will probably be the nth thread about DIY DSPs based on AD chips. After countless of hours trawling the forum for a suitable design that fits a plateamp application I haven't found the one. So I'm taking the chance that someone could point me in the right direction before I bite the bullit and invest the time to design something from the ground up (or modify an existing design eg. FreeDSP classic or Catamaran).
Requirements are:
1 in (mono) 4 out analog balanced via pins for XLR (in) and JST connections (out).
15V power to run off AUX power supply from amp module
The usual features to take advantage of Sigma studio (USBi, monitoring, etc.)
Distortion < 0.005
Optimised layout for platemounting (perpendicular to faceplate)
Anyone with any ideas?
Thankful for any suggestions or leads 🙌
Cheers.
/M
Maybe not exactly what you are looking for, but it will meet most of your requirements.
It was primarily developed for icePower amplifier modules.
https://github.com/f-io/dspCore
Cheers
It was primarily developed for icePower amplifier modules.
https://github.com/f-io/dspCore
Cheers
Member
Joined 2018