I run paralleled New Large Advents (3 ohm dips for sure) with an F6 (1.3A bias)
No problem for that amp.
Not a firstwatt amp but Sony Vfet2 is a very good amp for 4 Ohm speakers.
Also Burning Amps with push-pull source follower output.
It will also depend on speaker sensitivity. I have a 4 Ohm speaker that's over 100dB/2.83V. That speaker never sees more than 3V peak. So that speaker is not a problem for virtually any firstwatt amp.
Also Burning Amps with push-pull source follower output.
It will also depend on speaker sensitivity. I have a 4 Ohm speaker that's over 100dB/2.83V. That speaker never sees more than 3V peak. So that speaker is not a problem for virtually any firstwatt amp.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.