I welcome forum Users. 🙂
I have 4 Seas ER18RNX pieces at myself and I am searching for the good, checked draft of loudspeakers with applying them. Not yet I chose the tweeter.
For me somebody of you could help, to indicate the place, and maybe to divide own already checked?
Great thanks. 🙂
I have 4 Seas ER18RNX pieces at myself and I am searching for the good, checked draft of loudspeakers with applying them. Not yet I chose the tweeter.
For me somebody of you could help, to indicate the place, and maybe to divide own already checked?
Great thanks. 🙂
I would use this project, from ground up if you can't find any, substituting the drivers https://www.madisoundspeakerstore.c...ge-ca26rfx-h1305-10-coated-paper-cone-woofer/ with your driver https://www.madisoundspeakerstore.c...stige-er18rnx-h1456-7-reed-paper-cone-woofer/ reproducing the LF. It will give you another way of experimenting with a 3-way MTM that you can adapt to a 2way. D'Appolito configuration is a mix anyway. not only the looks from outside, so don't disregard it.
You can give a little more to the mids side in freq. range of the bottom woofer and a little attenuation on the top driver reproducing the mids because the 10" from Troels project has more ~2dBs in relation to the 7". Just an idea to work on.
Jenzen CA
You can give a little more to the mids side in freq. range of the bottom woofer and a little attenuation on the top driver reproducing the mids because the 10" from Troels project has more ~2dBs in relation to the 7". Just an idea to work on.
Jenzen CA
Several years ago, Dennis Murphy and I collaborated on a pair of MTM designs using your woofers with a dome tweeter and a ribbon tweeter. Meniscus Audio has kits for them:
ER18MTM Dome
ER18MTM Dome
There is a link in both to a writeup about these designs with cabinet details.
Paul
ER18MTM Dome
ER18MTM Dome
There is a link in both to a writeup about these designs with cabinet details.
Paul
- Status
- Not open for further replies.