DIY Passive LDR Attenuator in T Amp Case

Status
Not open for further replies.
Hiya, I've had a lightspeed attenuator for years and I love it (an original I saw on Ebay) although I had parts for the DIY Lightspeed Passive LDR Attenuator variant/clone too:

DIY Lightspeed Attenuator - Passive LDR Volume Control (optocouplers)

I'm about to build it but wondered if anyone else has used a T Amp case to host this type of attenuator. It seems perfect as the board needs RCA in and out plus Power and a volume control.

I suppose I'm "thinking out loud" here but I wondered if anyone had tried it, the board is small so it should fit but knowing my luck etc

Best
Nathan
 
Last edited:
Status
Not open for further replies.