I'm interested in building an output transformer. Push-Pull/UL taps/8/4 ohms outputs etc. 30Hz-45kHz frequency range maybe. 50 watts or so. for hi-fi.
Not sure on the tubes and design yet. Just investigating into the possibility of a DIY job.
I found this german site that seems to sell all the parts.
But the site is overwhelming and not easy to follow if you don't know what you are looking for especially as most of it is in German.
Looking for the E and I Laminations and winding core.
Has anyone had experience of purchasing from this store or any other recommendations?
Also any good tutorials of how to make these?
http://www.spulen.com/
http://www.geofex.com/Article_Folders/xformer_des/xformer.htm
Not sure on the tubes and design yet. Just investigating into the possibility of a DIY job.
I found this german site that seems to sell all the parts.
But the site is overwhelming and not easy to follow if you don't know what you are looking for especially as most of it is in German.
Looking for the E and I Laminations and winding core.
Has anyone had experience of purchasing from this store or any other recommendations?
Also any good tutorials of how to make these?
http://www.spulen.com/
http://www.geofex.com/Article_Folders/xformer_des/xformer.htm