DIY CD drive based on a computer CDROM

[pigoia]

Anyone have a .brd file for built a cdrom interface?
Thanks

 

[audiodesign]

I have found that with some audio cd your cdrom controller go in block at the end of the cd writing on display "Playing", have you a new firmware version ?

 

[roly3055]

SCH & PCB eagle Files

Here's the sch and pcb for eagle 4.16r2


Regards

Roly

 

[audiodesign]

I cannoct open your zip file, as the previous, please try to send the file separated no zip

 

[roly3055]

Check you email

I send an email with files included

 

[roly3055]

New ZIP

New Zip

 

[sklimek]

Hi, I received the MCLL Eagle files from roly3055 and was wondering if anyone has posted a BOM for this project. I can piece some of it from the schematic but was wondering:

AT89C51-12PC or AT89S52-24PC, does it matter, will codes work for both?

RN1 – is this an A103J SIP 10K resistor array?

trim pot value.

All the other values.

Anyway if someone could direct me to the right link (I have read the entire, but sure I missed it somewhere) it would be much appreciated.

Stan

 

[sklimek]

Here is the schematic -

 

[roly3055]

Schema

Here is the original schematic


Roly

 

[roly3055]

Codes

Codes and programmer

 

[fly71]

I'm interest a cdrom interface with PIC 16F877, wich project choose?
Sorry for my english

My e-mail cellui@yahoo.it

Thanks Luigi

Per Polmy, morpheus82, pigoia potete darmi un consiglio e un aiuto?

 

[fly71]

I'm interest a cdrom interface with PIC 16F877, wich project choose?
Sorry for my english


Thanks Luigi

Per Polmy, morpheus82, pigoia potete darmi un consiglio e un aiuto?

 

[Lucifix]

I'm interest a cdrom interface with PIC 16F877, wich project choose?

  Hello,
you can try this one, remote infos are here but there are also some
bugs in firmware that you need to know about.

Regards!
Lucifix

 

[lazenna]

Just wondering if any one has finished their cdrom cd players?Pics please.

 

[MCLL]

Here is my cd-rom player.

 

[Sergelisses]

Hi,

What about the power supply ,the Clock ,the Spdif output ?

Best regards

Serge
😎

 

[MCLL]

Hi,

What about the power supply ,the Clock ,the Spdif output ?

Best regards

Serge
😎

Include Power Supply, slim cd-rom internal analog output, no re-clock and SPDIF.

Just for fun....

😀 😀 😀

 

[lazenna]

did you buy a kit to run everything or did you diy from scratch

 

[Sergelisses]

My CD Drive with a PLEXTOR DVD 130A

The door is closed

The door is open

Inside :you can see the card under the PLEXTOR

The card : clock ,reclock and SPDIF interface


Serge

 

[DECKY999]

Just a question regarding the CDROM power supply. I am about to start building my version of this and I was wondering if I should treat both +5 and +12 volt supplies to the CDROM separate from any other digital circuits (buffers, DAC etc).

I know that mixing +12 CDROM and digital lines is no good but what about +5 CDROM supply?