Hi folks,
I'm new here, and I just FINALLY acquired all the parts to make my DIY projector:
Lens Triplet from DIYLABS
Fresnel
ASK impact 24 800X600 16.7
MH 400W setup
I'm waiting on my ASK to be shipped to me, but when it gets here I'm going to be very anxious to start. My question is this:
What kind of material is best for building the box? What are you guys using that is lightweight, heat resistant, and easy modified?
Any ideas/suggestions?? Thanks!
I'm keeping a digital picture diary as I go along, so that'll be posted as I progress for anyone interested.
Thanks,
Jason
I'm new here, and I just FINALLY acquired all the parts to make my DIY projector:
Lens Triplet from DIYLABS
Fresnel
ASK impact 24 800X600 16.7
MH 400W setup
I'm waiting on my ASK to be shipped to me, but when it gets here I'm going to be very anxious to start. My question is this:
What kind of material is best for building the box? What are you guys using that is lightweight, heat resistant, and easy modified?
Any ideas/suggestions?? Thanks!
I'm keeping a digital picture diary as I go along, so that'll be posted as I progress for anyone interested.
Thanks,
Jason