I have a couple of cheapish midbasses lying around, and I was thinking of removing the dustcap, and installing a phase plug.
since the cones are fairly delicate, ive changed my mind about that particular idea 😀
However, I would like to try and remove the magnet assembly from the rear of the basket, in order to get a nice pole piece vent drilled through. Of course swarf precautions taken.
I would just like to know if anyone has any tips on how i can do this safely, or if there is any solvent/method to help soften the bond.
since the cones are fairly delicate, ive changed my mind about that particular idea 😀
However, I would like to try and remove the magnet assembly from the rear of the basket, in order to get a nice pole piece vent drilled through. Of course swarf precautions taken.
I would just like to know if anyone has any tips on how i can do this safely, or if there is any solvent/method to help soften the bond.