There's a mysterious instruction which I cannot fathom:
What is Vs? How does one just "set" the source voltage of the amplifier at .5-1.0V? Is that VDC?
How do I do that?
Dave
What is Vs? How does one just "set" the source voltage of the amplifier at .5-1.0V? Is that VDC?
How do I do that?
Dave
You plug the tone generator in the amplifier, at a 100 Hz frequency. You start the tone generator with the amplifier dial on the lowest setting. You plug the multimeter at the + and - on the amplifier, you set it to measure an alternative signal and you climb slowly the dial on the amplifier to reach 1 Vac.
- Status
- Not open for further replies.