How are you going to get the slots cut in? I was thinking it'd be best to remove segments from the rings before assembly.
KM
KM
Yes, I realize there is a much easier way to build this.....with pvc pipe or the like.
I'm just doing it this way because I have the materials lying around.
Also, I strongly oppose efficiency, I eat my soup with a fork 😀
I'm just doing it this way because I have the materials lying around.
Also, I strongly oppose efficiency, I eat my soup with a fork 😀
Last edited:
Ha. I wasn't aware of a craze either! I'm eager to hear some impressions of the build, though!
Km
Km
Last edited:
Looking good! Is there enough room for the mid-tweets to breath? It looks like the magnet is right against the holes.
Wire those suckers up!
Kyle
Wire those suckers up!
Kyle
Yeah the 1st ring is chamfered.
I will have the rest built tomorrow.
The hard part is over. Lots of dust bro!
I will have the rest built tomorrow.
The hard part is over. Lots of dust bro!
Ah, okay. Are you going to do the DSP work on the computer or something like a miniDSP?
Kyle
Oh yeah, much clearer. Well, I'm intrigued to read your impressions once you get them running!
Kyle
Kyle
Design
Pics.
I haven't stuffed, measured or even listened yet. I'm waiting for speaker wire, which is coming tomorrow.
Pics.
I haven't stuffed, measured or even listened yet. I'm waiting for speaker wire, which is coming tomorrow.
- Status
- Not open for further replies.