I have a F3 amp,and I made a couple of 2way speakers.The bas is Scan speak 21w/8554 and i think therea a little lack of bass,does the F3 lack bass?Or is it the basses.
Every one of these amplifiers has different characteristics,
and I would categorize the F3 as having very fine midrange
and a sweet, slightly soft top end. It is not known for
having much punch and control on the bottom end, and has
a relatively low damping factor of about 8.
If you want more and better bottom end, you are probably
looking at an F5. Myself, I would consider bi-amping
the speakers.
😎
and I would categorize the F3 as having very fine midrange
and a sweet, slightly soft top end. It is not known for
having much punch and control on the bottom end, and has
a relatively low damping factor of about 8.
If you want more and better bottom end, you are probably
looking at an F5. Myself, I would consider bi-amping
the speakers.
😎
I have tested several modifications of F3 schematics and achieved more impressive bass by increasing an idle current and decreasing voltage amplification factor (increasing NFB) from 5 to 2.
As for improving highs, one may disconnect the chain for current source modulation, but this makes less bass at the same time.
If for Bi-Amping, I would definitely use F3 with disconnected modulation.
As for improving highs, one may disconnect the chain for current source modulation, but this makes less bass at the same time.
If for Bi-Amping, I would definitely use F3 with disconnected modulation.
I´m listenning on the F5 through my 2way diy speakers,and it has more bass/punch than F3.
Now mr Pass could you consrtuct an amplifier that combines F5/F3 in one amplifier that would be nice..
😱
Now mr Pass could you consrtuct an amplifier that combines F5/F3 in one amplifier that would be nice..
😱
- Status
- Not open for further replies.