this wont spin discs ive checket the usual suspects belt,lens clean ,
laser does the usual shuffle and with my camera was able to establish it works so i tested the spindle motor with ext supply its good .
so down to basics the check supplies.
+5v and -5v are good BUT the+8v and -8v are both +12v and - 12?
im wondering if during production they used a different centre tap tx
i will enclose cct
i entered the service mode and went through the various tests
so now im stumped
laser does the usual shuffle and with my camera was able to establish it works so i tested the spindle motor with ext supply its good .
so down to basics the check supplies.
+5v and -5v are good BUT the+8v and -8v are both +12v and - 12?
im wondering if during production they used a different centre tap tx
i will enclose cct
i entered the service mode and went through the various tests
so now im stumped
fixed
it was a plastic stud snapped off under main cam ,the black ons ,in case anyone is interested
it was a plastic stud snapped off under main cam ,the black ons ,in case anyone is interested
that sounds like it was more of a one off sort of an issue.