Hi, sounds like an odd one but how would I execute a DC servo for the F1, it's to drive a b&g planar via active crossover and I'm worried about DC offset causing problems over the long term by slowly drifting 😕
RC [help=]%[/help]
RC [help=]%[/help]
93-94dB Neo8 S, I know where your going so I'll quickly add I might not be using those nice IRFs (despite owning 100 or so) I'm just trying to cover my butt before I build the amp and discover there is an issue.
RC
RC
That sensitivity just seems a bit low for use with a 10W amp. That, and the F1 is a current-source (high output impedance) amp, which may not be appropriate for those speakers. I also doubt the 50mV offset that Mr. Pass quotes in the F1 service manual will hurt anything with those speakers. I suppose where I'm going is that it may be some effort to re-design something that is inherently inappropriate.
- Status
- Not open for further replies.