Hi everyone,
I have a Plinius Odeon amplifier with 6 individual modular amplifier boards, but this question is probably more generally.
The instructions say
This seems to be a big range to me, so my question is - it is ok as long as the voltage is within this range?
I have checked the boards and most are within the range with 1 way outside.
Should I be adjusting them all to be as close as possible? Or is it ok for amp to be -2.5V and another to be +2.8V?
TIA
I have a Plinius Odeon amplifier with 6 individual modular amplifier boards, but this question is probably more generally.
The instructions say
This seems to be a big range to me, so my question is - it is ok as long as the voltage is within this range?
I have checked the boards and most are within the range with 1 way outside.
Should I be adjusting them all to be as close as possible? Or is it ok for amp to be -2.5V and another to be +2.8V?
TIA
Going from my experience, ZERO volts is the thing to aim for.
I don't have the manual for that amp so..... I can't give an accurate professional answer.
I don't have the manual for that amp so..... I can't give an accurate professional answer.
Thanks for the quick reply.
So if I try to adjust so all the amps are close to zero volts as possible, then I should be good?
Thanks
As I said before, I don't have specific info on this amp, or a schematic/Service Manual, so I can't give any definite answer.
I'm a professional service tech, not a magician, sorry.
