I am thinking of using Dayton Audio - RS225-8 - 8" woofer in a ported enclosure to act like a subwoofer (operating from 80Hz and below). Also this arrangement can be used as a woofer (300Hz and below.). And would switch between the two arrangement by changing filters.
how well do you think should it perform as exclusive subwoofer? This driver has a internet review of being a low distortion driver.
Ref: Dayton Audio RS225-8 8" Reference Woofer 8 Ohm
how well do you think should it perform as exclusive subwoofer? This driver has a internet review of being a low distortion driver.
Ref: Dayton Audio RS225-8 8" Reference Woofer 8 Ohm
It has got a phase plug so it might chuff, depending on the tolerances. Furthermore its Xmax is only 7 mm. Other than that, it will work fine.
I was wondering how to handle the phase plug. 7mm Xmax is something I thought of to be too low. but not sure how would it work in my case.
Thanks for the reply.
Thanks for the reply.
Did an MLTL awhile back for someone, but don't recall them building it or at least letting me know how it turned out. Tuned to Fs it's Xmax limited to ~50 W.
GM
GM
- Status
- Not open for further replies.