DAC output voltage

[daredevil_kk]

Hi guys,

My dac is giving a output of 0.3v for a 0dB 1khz. Is it too low and what is the effect down stream, beside having to crank up the vol?

Thanks,

KK

 

[Iain McNeill]

I assume you mean 0.3Vrms which would be 0.85V p-p. It all depends on your DAC supply rails so this might be reasonable for a 1.8V rail DAC. As long as the DAC is achieving the 96dB signal-to-noise that 16bit digital aspires to you should have no problem with adding clean gain.

I have seen 1Vrms as a more typical 0dBFS level. Care to share the DAC schematic and we could comment further.

 

[daredevil_kk]

Hi Iain,

Yup, it is 0.3Vrms. As for the circuit, it is a TDA1541A to a I/V 34ohm resistor to step-up transformer. It has a output impedance of 4.5kohm. My intention is to put a unity non-inverting buffer after that.

Cheers,

KK

 

[Iain McNeill]

Hmmm. Doesn't seem like it's stepping up much. Sounds like it may be mismatched somewhere. Do you have full specs on the transformer like primary inductance, turns ratio etcetc?

 

[daredevil_kk]

From my measurement, the voltage after the I/V is 0.043Vrms. Hence, the transformer is a 16.9dB gain. I don't have much info on the transformer.

KK

 

[daredevil_kk]

Oh yeah, it is an input trans for a tube amp.

Cheers.

KK

 

[Iain McNeill]

43mVrms is about right for 4mA pk into 34ohm so that's encouraging.

Without a schematic and measurements it's hard to say how it works.🙂

 

[daredevil_kk]

The DAC is a simple I2S to the TDA1541A to the passive I/V. Nothing complex about it. The only thing that I thinking is to leave it alone with a low line out or change the value of the I/V or change to a higher step up trans.

Thanks Iain.

KK