Yes, sure i was planning on measuring each driver separately, and also the hfs with the mid and the lfs with the mids. I will come back as soon as i have something^^ thank you!
Hi, so i have the measurements in holm, but my problem is that i had the mic 50cm from the speaker, and the speakers were left in their place. The response of the lf is measured with both 10icnh speakers connected in series. The Hf was measured with two drivers in paralell. I cannot really set the gating, i guess the measurements are far from good,(i was not the one to do the measurements and they certainly were not measured in a anechoic chamber... Could you help me with the gating, maybe with making those damned FRD files? Thanks a lot for your help. If you do not have time to help me out with the FRD files it is not a problem, but i have no clue which part of the impulse response counts as the"second peak" so i identify see room reflections. Could you please set the gating for me? Thank you again for your time and help!
Did anything come out of this? I have never personally heard speakers made by admark but there are companies like Sanway, LAudio etc who I have purchased speakers from and they sound quite brilliant when used with original processors, amplifiers etc. I also had a doubt. Can't we just take an original box and measure the original crossover unit, get the exact same components and clone the circuit like that? In any case, I'd very much like to know how this goes. If any of you have had any success or can make these network boards then I'd very much like to purchase a few from you. Cheers!