Crossover Help Required

[colmo]

Hi Steve,
As I said not sure how July got there.
I am not Polish although sometime ago I had a good friend who was Polish.
I replied on my tablet earlier and think I must have pressed something by mistake.

I only looked at the Polish site because I could use Google to translate everything.
Anyway getting back to my ideas it was very kind of you to look through old designs etc to assist me.
Unfortunately there are a couple of snags with the Elok design, first it is200mm wide and I am looking for a 175 mm width to please Mrs. I suppose it wouldnt matter if I changed it though as I do not need much baffle step as the speakers will be against the back wall, what do you think.
2nd problem is that the crossover is at 4000hz and I have read that that is much too high for the 15NRX so it would need a big change to the crossover again what do you think.
Well again thank you for your assistance.

 

[system7]

I wouldn't think the exact baffle width is all that critical, I mean, will you hear it? 😀

I was just trying to save your project...

Actually, I have found something better and it's 2.5kHz crossover:

SB15NRXC30-4 + SB29RDNC 2-way Passive Crossover Design - Madisound Speaker PDF Library

That SB15NRXC30-4 woofer IS available:
SB Acoustics SB15NRXC30-4 Midwoofer

Might be an issue on availability with the 92dB SB29RDNC-C000-4 tweeter:
SB Acoustics SB29RDNC-C000-4 Tweeter

But it's a current model:
SB29RDNC-C000-4 / Fabric – Sbacoustics

No problem converting to series MTM.

 

[colmo]

Hi Steven
Very kind of you to spend time trying to help.
I am not too keen on the NRX not much low output.
I think I will spend sometime deciding which SB15 drivers model best and then pay someone to design the crossover.
Thanks again for your time and efforts.