Hello, I've old 2 Way Bookshelf speaker from old Sony HIFI Tape, when I look inside, there's only hipass filter capacitor on tweeter, so I decide to design passive Crossover.
I should stick only with 1 uf, 2.2 uf, 3.3 uf, 4.7 uf and 10 uf capacitor only, because it diffcult to find other value of non polar caps in my country.
here is my schematic:
and here the result from simulation:
and here TSP, FRp and ZMA file:
https://www.dropbox.com/sh/wke3g5wxgi8dw00/AADWy2j8Ynirbz6zwxVEEYyza?dl=0
can you guys give suggestion, It's a bit too much but I want near flat response from that speaker
Regard's
I should stick only with 1 uf, 2.2 uf, 3.3 uf, 4.7 uf and 10 uf capacitor only, because it diffcult to find other value of non polar caps in my country.
here is my schematic:
and here the result from simulation:
and here TSP, FRp and ZMA file:
https://www.dropbox.com/sh/wke3g5wxgi8dw00/AADWy2j8Ynirbz6zwxVEEYyza?dl=0
can you guys give suggestion, It's a bit too much but I want near flat response from that speaker
Regard's
Last edited: