If the cap and missing resistor are in series and one end of the pair connects to the negative speaker terminal and the other end of the pair connects to the positive speaker terminal, it's a zobel network. The amp will work without it. There should be one for each channel.
If you can't find the fault, post the voltages on the TL494 (or whatever they're using).
IC#
Pin 1:
Pin 2:
Pin 3:
Pin 4:
Pin 5:
Pin 6:
Pin 7:
Pin 8:
Pin 9:
Pin 10:
Pin 11:
Pin 12:
Pin 13:
Pin 14:
Pin 15:
Pin 16:
If you can't find the fault, post the voltages on the TL494 (or whatever they're using).
IC#
Pin 1:
Pin 2:
Pin 3:
Pin 4:
Pin 5:
Pin 6:
Pin 7:
Pin 8:
Pin 9:
Pin 10:
Pin 11:
Pin 12:
Pin 13:
Pin 14:
Pin 15:
Pin 16:
It has a 494P.
IC#
Pin 1: 0.003
Pin 2: 4.85
Pin 3: 0.075
Pin 4: 0.010
Pin 5: 1.492
Pin 6: 3.662
Pin 7: 0.002
Pin 8: 12.30
Pin 9: 5.25
Pin 10: 4.86
Pin 11: 12.45
Pin 12: 12.61
Pin 13: 4.97
Pin 14: 4.97
Pin 15: 2.744
Pin 16: 2.471
The power fets check out on the DVM, but one of them appears to have been replaced and has a crack in it. Both are IRFZ44. I removed the one with a crack in it (Q48) so only Q49 remains. Q48 on the bench confirms it is messed up; but not shrted. Transformer displays a "decent looking" sqaure wave on the scope but only +/- 2.5v.
IC#
Pin 1: 0.003
Pin 2: 4.85
Pin 3: 0.075
Pin 4: 0.010
Pin 5: 1.492
Pin 6: 3.662
Pin 7: 0.002
Pin 8: 12.30
Pin 9: 5.25
Pin 10: 4.86
Pin 11: 12.45
Pin 12: 12.61
Pin 13: 4.97
Pin 14: 4.97
Pin 15: 2.744
Pin 16: 2.471
The power fets check out on the DVM, but one of them appears to have been replaced and has a crack in it. Both are IRFZ44. I removed the one with a crack in it (Q48) so only Q49 remains. Q48 on the bench confirms it is messed up; but not shrted. Transformer displays a "decent looking" sqaure wave on the scope but only +/- 2.5v.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- Crossfire CFA202 wont power up