Ok guys here is my problem.
I have a Crossfire 360.1 and I am having a little bit of problems with it. It powers up just fine and never goes into protect after boot up, but when I install all the output speaker wires I get little to no sound at the speaker end. I am not sure what would be the problem please give me a little guidence and possibly a way to fix it or check it out to narrow the problem down. thanks a lot.
I have a Crossfire 360.1 and I am having a little bit of problems with it. It powers up just fine and never goes into protect after boot up, but when I install all the output speaker wires I get little to no sound at the speaker end. I am not sure what would be the problem please give me a little guidence and possibly a way to fix it or check it out to narrow the problem down. thanks a lot.
ok I am trying butthe camera I have is horrible and it all looks real dark how can i get a better picture without white washing it ? can anyone help ?
There is a section on getting better photos on the basic amp repair page (link in sig line below).
- Status
- Not open for further replies.