Crimper suggestions

[bloozestringer]

I've got a set of ratcheting crimpers (Kleins) for doing insulated terminals and was going to pick up some regular Klein 1005's for non-insulated. Can anyone recommend a decent crimper for these style terminals?

 

[Ixnay]

I just don't know if a decent crimper is made for this design. I would carefully crimp with maybe needle nose, and the solder, followed by an adhesive heat shrink. And it probably goes without saying, but there is a range of quality with these sorts of connectors. A great connector gives no grief.

 

[Pars]

I bought one of these for use on terminals similar to this, Molex KK 2.54mm, Molex SPOX, TE D5200 Dynamic, etc. and it works pretty well.
https://www.amazon.com/dp/B078WPT5M1?psc=1&ref=ppx_yo2ov_dt_b_product_details

 

[kapitiaudio]

Normally it's neccessary to buy the manufacturers correct crimper for the terminal being used otherwise sub-optimal crimping is likely.

 

[Jacob29]

I bought one of these for use on terminals similar to this, Molex KK 2.54mm, Molex SPOX, TE D5200 Dynamic, etc. and it works pretty well.
https://www.amazon.com/dp/B078WPT5M1?psc=1&ref=ppx_yo2ov_dt_b_product_details

I have the same ones haven't had any issue

 

[bloozestringer]

I’d seen this one on Amazon. But review on these cheap crimpers are always hit or miss. The hood thing is that they go to 16awg so good for internal speaker connections.

Crimpers.