I just moved to Germany and want to configure my two Verastarr amps for 220-230v. I have an SSA-644 (same internally as the SSA-64) with a handwritten schematic for a 64, but its not very clear and some annotations are obscured, but apparently its straightforward. I beleive the OEM manufacturer for Verastarr was Cinepro who were then acquired by AB International after the untimely passing of the founder. Bob at AB International is no longer responding to queries (possibly as that company too is defunct.... URL no longer active).
There are two unused wires on the toroidal transformer that I assume get connected to the junction box with the black circular ICL component.
All spade pins are used for 220v vs 110v operation. This is how my SSA-644 is setup for 110v. Can anyone provide some guidance as to how the wires should be connected going from 110v to 220v?
Thanks in advance
There are two unused wires on the toroidal transformer that I assume get connected to the junction box with the black circular ICL component.
All spade pins are used for 220v vs 110v operation. This is how my SSA-644 is setup for 110v. Can anyone provide some guidance as to how the wires should be connected going from 110v to 220v?
Thanks in advance
Last edited: