Hi all,
I am trying to put a simple voltage regulator into stanby-mode using an open collector outbput from an atmega.
I am not sure though that the way I achieved this result is very academic - I have not used any pull-up resistor as stipulated in the regulator datasheet as I could not figure out how exactly to do it.
The sim is attached hereunder.
Could someone with more insight kindly point me on how to implement this correctly ?
Thanks in advance,
Max
I am trying to put a simple voltage regulator into stanby-mode using an open collector outbput from an atmega.
I am not sure though that the way I achieved this result is very academic - I have not used any pull-up resistor as stipulated in the regulator datasheet as I could not figure out how exactly to do it.
The sim is attached hereunder.
Could someone with more insight kindly point me on how to implement this correctly ?
Thanks in advance,
Max
