Hi Folks,
I have a question about connecting a Class-D amp from Connex Electronic to the amp and speaker.
- I see that the Cxd500 inputs have +In, -In and two GND pins.
How do these get connected to preamp output from receiver? I only have a + and - coming from pre-amp. Do these go to +In and -In? Or +In and Gnd of amp?
Similarly,
- The CXD500 outputs have the +vcc, -vcc and two grounds.
How do these get connected to speaker terminals? Does the +Vcc and -VCC go to speaker + and -?
btw, this is being used in a subwoofer.
Regards
Ajay
I have a question about connecting a Class-D amp from Connex Electronic to the amp and speaker.
- I see that the Cxd500 inputs have +In, -In and two GND pins.
How do these get connected to preamp output from receiver? I only have a + and - coming from pre-amp. Do these go to +In and -In? Or +In and Gnd of amp?
Similarly,
- The CXD500 outputs have the +vcc, -vcc and two grounds.
How do these get connected to speaker terminals? Does the +Vcc and -VCC go to speaker + and -?
btw, this is being used in a subwoofer.
Regards
Ajay
balanced input + g -
vcc+ / vcc- are where u connect your power supply
then u have Ground - and output + to your speaker
vcc+ / vcc- are where u connect your power supply
then u have Ground - and output + to your speaker
- Status
- Not open for further replies.