For those of you who swap boards in the same chassis, what connector for the wires do you use? I assume you don't solder and de-solder every time you switch boards.
I've started liking Molex Mini Fit Jr 4.2mm connectors, the ones that are pretty much the standard power connector inside desktop computers.
If I was doing it I would use Deans plugs for power supply connections.
For low current signal connections, I'm starting to think maybe rj45 ethernet connection might be better than ribbon connector. That's just a guess on that one.
For low current signal connections, I'm starting to think maybe rj45 ethernet connection might be better than ribbon connector. That's just a guess on that one.
Last edited:
- Status
- Not open for further replies.