Hello,
1) First of all I am a really newbie
2) I am trying to build a car-amp with the TDA1562Q
3) I see it's a one channel amp. for 4 ohm speaker
My question is: Can I connect 2 speakers (two 4-ohm = 2x4 ohm) to only one IC amp.
The idea is to build two of these amps. so I can get stereo. But connect rear AND front speakers with just 2 IC.
How? Thank you!
Ricardo Toma
1) First of all I am a really newbie
2) I am trying to build a car-amp with the TDA1562Q
3) I see it's a one channel amp. for 4 ohm speaker
My question is: Can I connect 2 speakers (two 4-ohm = 2x4 ohm) to only one IC amp.
The idea is to build two of these amps. so I can get stereo. But connect rear AND front speakers with just 2 IC.
How? Thank you!
Ricardo Toma
nope
not rated at all in the datasheet wouldnt recommend unless u wanted to go in series 4+4= 8 ohms and have about half the output power. Would recommend 1 chip per speaker.
not rated at all in the datasheet wouldnt recommend unless u wanted to go in series 4+4= 8 ohms and have about half the output power. Would recommend 1 chip per speaker.
- Status
- Not open for further replies.