Let me begin by saying that I am a complete novice at this.
I have been working with Bagsby's worksheet trying to finalize my plots prior to loading them into PCD. Where I get stuck is; I am building an odd speaker, it will be an MTM with bi-pole woofers (4"). My understanding is that by utilizing a bipole alignment, I should get not only a pass on BSC losses, but also an increase in efficiency. I am stuck, however, in process trying to get four drivers modeled, bypassing BSC, and then figuring out how to roll off the back drivers at the baffle-point...which would be around 1700Hz or so.
Does anyone have any idea where to point me?
I have been working with Bagsby's worksheet trying to finalize my plots prior to loading them into PCD. Where I get stuck is; I am building an odd speaker, it will be an MTM with bi-pole woofers (4"). My understanding is that by utilizing a bipole alignment, I should get not only a pass on BSC losses, but also an increase in efficiency. I am stuck, however, in process trying to get four drivers modeled, bypassing BSC, and then figuring out how to roll off the back drivers at the baffle-point...which would be around 1700Hz or so.
Does anyone have any idea where to point me?