• The Vendor's Bazaar forum is for commercial offers and transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Combined Onaudio thread. (23 threads)

Status
Not open for further replies.
Jump to Latest
#602
OnAudio,
thanks for the references. I had already ordered some Elna capacitors of that same value when I order the other parts for the build, I'll assume they are comparable for now. On the small film capacitor so that I am clear on this subject. From what I have read the film capacitors value is not that important right, just that there is a film capacitor in parallel with the electrolytic cap and removes issues with those caps. So if I happen to have a 10 or 100 mfd 100v cap sitting around would it matter if I just used that value or is there a problem with using a higher value cap? On the rectifier side are there any special qualities of one over another. Does the speed of the rectifier have anything of consequence here, would a Schottky diode bridge have any advantage here?
 
Last edited:
#604
OnAudio,
Thanks for the response. I know I already have some bridge rectifiers like this in my parts bin that I got from Apex Jr. and are just sitting around. I have some transformers also that I will have to look at their rating and see what is required here. They are not torroids but shouldn't matter.

Steven
 
#612
The Amplifier Tasting Group is tasked with ensuring that the world gets to built, experience and rate.

http://www.diyaudio.com/forums/solid-state/198500-symef-amplifier.html

http://www.diyaudio.com/forums/solid-state/199196-new-dawn-1diffqc-amplifier.html

http://www.diyaudio.com/forums/solid-state/207746-hal-opb-amplifier.html

http://www.diyaudio.com/forums/solid-state/211972-1diffef-amplifier.html

http://www.diyaudio.com/forums/solid-state/211478-experiment-1diffsym2-audio-amplifier.html

http://www.diyaudio.com/forums/solid-state/211966-chameleon-mode-2diffef-amplifier.html

The assumption is that these are among the planets finest amplifiers.

The steering committee will comprise the current 16 member donor group who donated and voted for the latest project FREE PCB project amplifier. Their term expires with the incoming of a new donor group.

During their term the steering committee will oversee the design and fabrication the selected free PCB.

100 PCBs will be made

32 belong to the steering committee

32 will go on offer as free PCBs at a secret time and date set by the committee

32 will go on offer as a gift for a small donation of about $30 (The 16 persons who donate will select the new FREE project and will become the new steering committee)

4 will be split up by persons recruited by steering committee such as PCB designer
 
#620
OnAudio,
I hope to start building this board perhaps today. I have to set up a small work area that I can work and do this right. Still waiting on the Mouser parts and a few things I will need to do the psu. I'll have to figure out what I am going to put it all in, probably order a nice chassis to put it in.

Steven
 
Status
Not open for further replies.
Top Bottom