i was at home depot the other day and found some factory pre-cut 3/4" particale board. 36"x7.5".i figured this might work to put together a small pair of floor standers.i picked up a 2 bundles of 5 for $24 ,choped one piece at 6" for tops/bottoms and assembled.to my surprise,the cuts were accurate.everything fit very nicely.
less than an hour i had a couple 23l boxes(before bracing)
this might be good for people with limited tools and skills.these pieces are actually "risers" for stairs.you will not find them in the normal lumber section.
figured this might be helpful to some
glen
less than an hour i had a couple 23l boxes(before bracing)
this might be good for people with limited tools and skills.these pieces are actually "risers" for stairs.you will not find them in the normal lumber section.
figured this might be helpful to some
glen
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.