API: API 550A 3transistor buffer : Free Download, Borrow, and Streaming : Internet Archive
How would I change the input and output impedance on the circuit attached above? I want an input impedance of 140K ohms and an output impedance of 600 ohms.
How would I change the input and output impedance on the circuit attached above? I want an input impedance of 140K ohms and an output impedance of 600 ohms.
Well you could add 560 ohms in series with the output, change R6 to 150k, C1 to 560pF,
but then you'd have a -6dB attenuator into 600 ohms.
Buffers are low output impedance so the the voltage gain is unity whatever the load.
You'd need a different circuit to get x2 voltage gain suitable for driving a 600 ohm output resistor into 600 ohm load.
but then you'd have a -6dB attenuator into 600 ohms.
Buffers are low output impedance so the the voltage gain is unity whatever the load.
You'd need a different circuit to get x2 voltage gain suitable for driving a 600 ohm output resistor into 600 ohm load.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.