Hi,
I have a cdpro2 with about 4 or 5 tda1541 on the shelf for the last 3 yrs .
A good friend who owned a high-precision machined shop call me last week and kindly offer me to built the cd player as a R and D project.
I am still work on the design and the project should start within a month.
My goal is to make the CD as simple as possible, one box with 16 bit no o/s, no output design yet, but probably passive since the preamp will have a good drive ability.
I just need a good simple PSU with the correct on/off sequence and a control board with display.
I know some kit are available but i dont want to order all over the world at different place, i want this project to be top notch and able to compete with the best.
It might be possible to built a very few extra unit, as to be confirm.
Thank's
I have a cdpro2 with about 4 or 5 tda1541 on the shelf for the last 3 yrs .
A good friend who owned a high-precision machined shop call me last week and kindly offer me to built the cd player as a R and D project.
I am still work on the design and the project should start within a month.
My goal is to make the CD as simple as possible, one box with 16 bit no o/s, no output design yet, but probably passive since the preamp will have a good drive ability.
I just need a good simple PSU with the correct on/off sequence and a control board with display.
I know some kit are available but i dont want to order all over the world at different place, i want this project to be top notch and able to compete with the best.
It might be possible to built a very few extra unit, as to be confirm.
Thank's
Looking for mechanical
Hi, I'm working in collaboration with another Montrealer to make a CD-Pro2M player.
We've got a fair amount done, but would welcome the opportunity to collaborate with somebody else.
Frankly, the case design is our weakest link right now.
Hi, I'm working in collaboration with another Montrealer to make a CD-Pro2M player.
We've got a fair amount done, but would welcome the opportunity to collaborate with somebody else.
Frankly, the case design is our weakest link right now.
Hi Matt,
Thank's for your reply!
I need to confirm a few thing first with my friend just to make sure we're going in the same direction.
Since this project should be either¨cost no object¨for our own passion or with a commercial goal and all the associate constraint.
Than, i will definitly contact you to for further detail and dicuss a possible collaboration.
Our major skill is design and mechanic aspect.
My friend is a specialist in high tech telecom machined prototype so the mechanical aspect shouldn't be a problem.
Thank's for your reply!
I need to confirm a few thing first with my friend just to make sure we're going in the same direction.
Since this project should be either¨cost no object¨for our own passion or with a commercial goal and all the associate constraint.
Than, i will definitly contact you to for further detail and dicuss a possible collaboration.
Our major skill is design and mechanic aspect.
My friend is a specialist in high tech telecom machined prototype so the mechanical aspect shouldn't be a problem.
- Status
- Not open for further replies.