Great Scott
Leave the poor man alone. He is trying to be productive and not waste all day on the forum. By the way, I heard that is not his real name.....
H.H.
Leave the poor man alone. He is trying to be productive and not waste all day on the forum. By the way, I heard that is not his real name.....
H.H.
Re: Facial scars
Not at the time of the picture. Later that night I opened the front door to the house into my forehead.
How did you get this idear .. No i wan't ask! I know what it is like! You can't explain it without dump questions from friends!!
So if we are so funny...........why didn't anyone figure out our April Fools jokes. Explain that one, sonny boy. jokes!? i haven't seen any 😀 I think people with english as there second language is somehow excused from not understanding them.. But for you country fellows and the aussies and brits!! That is another story.. I think should be so.
I am serius... A forum without humor isn't fun at all and boring to.
To get back to the CCS i am going to try the 4-BJT current source in two or 3 weeks.
Right know i have to get the control part for my preamp up and working. I have forgotten that i made a weldcontroller(spotwelding) with the same controller onboard and 4 keys, 2 7-segment.. I have some spareboard so i am going to make the software on one of them.
😉
Sonny
Not at the time of the picture. Later that night I opened the front door to the house into my forehead.
How did you get this idear .. No i wan't ask! I know what it is like! You can't explain it without dump questions from friends!!
So if we are so funny...........why didn't anyone figure out our April Fools jokes. Explain that one, sonny boy. jokes!? i haven't seen any 😀 I think people with english as there second language is somehow excused from not understanding them.. But for you country fellows and the aussies and brits!! That is another story.. I think should be so.
I am serius... A forum without humor isn't fun at all and boring to.
To get back to the CCS i am going to try the 4-BJT current source in two or 3 weeks.
Right know i have to get the control part for my preamp up and working. I have forgotten that i made a weldcontroller(spotwelding) with the same controller onboard and 4 keys, 2 7-segment.. I have some spareboard so i am going to make the software on one of them.
😉
Sonny
Why?
Back to the first question: What was the purpose of the current source and how good should it be?
Back to the first question: What was the purpose of the current source and how good should it be?
Purpose: high impedance.
How good: > 1M ohm. More is better.
Sensitivity to variations with load should be first addressed with a stiff power supply.
Jocko
How good: > 1M ohm. More is better.
Sensitivity to variations with load should be first addressed with a stiff power supply.
Jocko
- Status
- Not open for further replies.