Cascaded Switching Regulator Stability

Status
Not open for further replies.
Member
Joined 2002
Paid Member
The input impedance of any moderately efficient switching voltage regulator is negative, because the input current decreases as the input voltage increases.

This creates a problem in power distribution systems that use cascades of regulators. The first regulator has to handle a negative impedance load. Since the output impedance of a regulator is inductive (it goes up with frequency as the control loop dies out) and there is an output capacitor on it, it is easy to get an oscillator: inductor and capacitor and negative resistor in parallel.

What can be done to solve this problem, assuming that there is a necessity to regulate the input of the switching regulators because of requirements of other things connected to their input rail?

-- mirlo
 
obviously a problem for telco's

higher bandwidth error amplifier -- and of course the switcher is going to want to see a minimal current load (or else the values of the "magnetics" -- both in dollars and physical units, become unrealistic and expensive).

Linear Tech, Maxim and National have application notes specifically addressing the topic. I am sure that TI does as well.
 
Status
Not open for further replies.