Hello, I am using camilladsp gui which is part of fusiondsp on Volumio RPI4.
When I create config pipelines it will successfuly load them into dsp, and if I immediately fetch back from dsp it shows correctly in the config tabs. But when I play a song it reverts back to a previous PEQ config created in Fusiondsp. I have tried loading different configs with same result. I set the fusiondsp into Camilla gui mode.
I also note that the Files/Configs has the second column, which selects the config as active, is greyed out with the message that the backend is unable to store the config.
Last, I notice that the attenuation changes when loading a config from the shortcuts, but it seems to change again when clicking the same config again. This is a fairly reliable symptom. If this a fusiondsp issue, I can re-post with balbuze. Any assistance would be greatly appreciated.
When I create config pipelines it will successfuly load them into dsp, and if I immediately fetch back from dsp it shows correctly in the config tabs. But when I play a song it reverts back to a previous PEQ config created in Fusiondsp. I have tried loading different configs with same result. I set the fusiondsp into Camilla gui mode.
I also note that the Files/Configs has the second column, which selects the config as active, is greyed out with the message that the backend is unable to store the config.
Last, I notice that the attenuation changes when loading a config from the shortcuts, but it seems to change again when clicking the same config again. This is a fairly reliable symptom. If this a fusiondsp issue, I can re-post with balbuze. Any assistance would be greatly appreciated.
It's probably an issue with fusiondsp or how it's configured. Try reaching out to balbuze first.
Wonderful system btw. 65536 taps on both channels 33% cpu on RPI4! I really like that one can make dynamic changes, say ms of delay, really speeds up refinement iteration. You must have put tremendous thought into the design.