I can only strongliest recommend to draw your own libraries.
Sure that hurts at the beginning but it will save you from a lot of erroneous prototype boards.
If you prefer not to draw them yourself, be sure to check all parts (clearances, pin assignments, dimensions etc.) used in your design before submitting the board to the board house. It will save you money & time!
Enjoy experimenting!
Sure that hurts at the beginning but it will save you from a lot of erroneous prototype boards.
If you prefer not to draw them yourself, be sure to check all parts (clearances, pin assignments, dimensions etc.) used in your design before submitting the board to the board house. It will save you money & time!
Enjoy experimenting!
- Status
- Not open for further replies.