Hi all,
I'm going to build this BHL (attached). And there are few matter I dont know how to solve.
1. How to calculate dimension of each piece of MDF basing on this schematic? Or if you built it, could you provide me exactly what happened?
2. Polywood and MDF, what's the best choice in this case? 20mm or 25mm, what's better?
3. How about the hole 67mm rite on front side, it's to hang on a treble or it's a part of enclosure?
That's it!
Rgds,
Cominup
I'm going to build this BHL (attached). And there are few matter I dont know how to solve.
1. How to calculate dimension of each piece of MDF basing on this schematic? Or if you built it, could you provide me exactly what happened?
2. Polywood and MDF, what's the best choice in this case? 20mm or 25mm, what's better?
3. How about the hole 67mm rite on front side, it's to hang on a treble or it's a part of enclosure?
That's it!
Rgds,
Cominup
Attachments
Drawing
probably the best way to start is to input into a CAD/Drawing program to figure out the angles...
probably the best way to start is to input into a CAD/Drawing program to figure out the angles...
coral enclosure
Did you made the enclosure for Coral beta 10? Just wont to ask how you are happy. I both Cora Beta 10 nice condition last week, now I need to make a decision what design - BLH or BR.
Hello.
Did you made the enclosure for Coral beta 10? Just wont to ask how you are happy. I both Cora Beta 10 nice condition last week, now I need to make a decision what design - BLH or BR.
