For Sale Buffalo III (multichannel) upgraded with ES9028Pro

[Dimdim]

For sale is my Buffalo III that has been upgraded by myself with an ES9028Pro. See here: https://www.diyaudio.com/community/threads/buffalo-iii-upgraded-with-es9028pro.307900/

I would prefer to sell the complete set of:

• Buffalo III with 9028Pro and upgraded regulators (LT3042).
• TPA Mercury I/V stage ( http://twistedpearaudio.com/linestages/mercury.aspx )
• Amanero Combo384 USB interface with U.FL cables and adapters for the B III ( https://www.amanero.com/ )
• Arduino Due - based controller with isolator shield and 3.2" TFT monitor (see http://www.dimdim.gr/arduino/tft-hifiduino-pro-project/ and http://www.dimdim.gr/arduino/universal-signal-isolator-shield-for-the-arduino-due/ ).

Note that this board is actually capable of multichannel output, since it is a Buffalo III. However it is currently configured for stereo output. To use it in multichannel mode one would need to use a multichannel-capable USB receiver, de-solder a few jumper resistors from the bottom of the board and modify slightly the Arduino code.

The current price from twistedpearaudio.com just for a new Buffalo-IIIsePro-28 with a Mercury I/V stage is $578 + tax + shipping.

Asking price for all of the above is 350€ inc. PayPal fees and shipping worldwide (Registered Mail).

 

[scobham]

Hi is this still available?

 

[Dimdim]

Yes, it still is.

 

[scobham]

PM Sent

 

[Tilo8888]

Hi Dimdim, I found your post right now and wonder if the complete set is still available for sale? Especially I am interested in the Mercury I/V stage but would also buy the whole set. Kind regards from Germany, Tilo

 

[Dimdim]

Hi there Tilo,

I'm afraid that the entire set has been sold.

Take care,
Dimitris

 

[Tilo8888]

Hi Dimdim,

thank you for your quick reply, so I have to keep on searching …

Kind regards, Tilo

PS: Your projects are very impressive. 🙂