hi at all 
Im using four 3040 schottky diode in to3p-3 case,recycled by some atx supply... for rectify 12v toroidal transformer for a very high quality tda7297 hahahah
this is the old trasformer...
There are no contraindications for this use?
or it's better a normal single case bridge rectifier?
Im using four 3040 schottky diode in to3p-3 case,recycled by some atx supply... for rectify 12v toroidal transformer for a very high quality tda7297
hahahahAn externally hosted image should be here but it was not working when we last tested it.
this is the old trasformer...
There are no contraindications for this use?
or it's better a normal single case bridge rectifier?
hi at all
Im using four 3040 schottky diode in to3p-3 case,recycled by some atx supply... for rectify 12v toroidal transformer for a very high quality tda7297
An externally hosted image should be here but it was not working when we last tested it.
this is the old trasformer...
There are no contraindications for this use?
or it's better a normal single case bridge rectifier?
They are ok for the purpose. Relatively low-voltage ones, but enough for your 12V. All the rest parameters are fine, plus schottky are faster than average rectifiers, which is always good.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.