I just got a bride of zen and i would like to make sure that it is set up properly as it has been in storage for awhile.
I can't seem to find any documents that will tell me where and what to measure for the pot set up.
Can someone help me out??
Thanks...
I can't seem to find any documents that will tell me where and what to measure for the pot set up.
Can someone help me out??
Thanks...
I see that adjusting the bias to 40ma is done by adjusting P102 to get 4v across R108.
How should I set up P101??
How should I set up P101??
Forget I said that, I realize that p101 is the volume control...duh!!
I measured approx 3.6v across R108 so my bias is slightly abpve the 40ma, Is that correct??
I have read other places that the bias should be set lower to reduce clipping, somewhere around 29-32ma and needs to be set with a scope which I don't have.
If this is the case what would the voltage drop across R108 be to get 30ma??
I measured approx 3.6v across R108 so my bias is slightly abpve the 40ma, Is that correct??
I have read other places that the bias should be set lower to reduce clipping, somewhere around 29-32ma and needs to be set with a scope which I don't have.
If this is the case what would the voltage drop across R108 be to get 30ma??
- Status
- Not open for further replies.