Steve, i have not sent out any pcb's yet, as i think it would be a lot easier and cheaper to send them all at once. Do you know when they should be arriving?
Rhys
Rhys
Rysh the package should arrive early nextweek (mon-tuesday). I made a error on the shipping. Again, if any body needs seperate shipping I will do so.
Steve
Steve
Hi,
I've read the about this amp on the designers web page and was about to send him an email, then I saw this thread- are there any pcb's left - both amp boards and DRV134 boards?
best regards
I've read the about this amp on the designers web page and was about to send him an email, then I saw this thread- are there any pcb's left - both amp boards and DRV134 boards?
best regards
folkeb said:
There will be DRV134 boards left, but at the moment there are only 2 bpa150's left.
I have finished the drv134 layout last night, built a prototype pcb and it seems to be working just fine. I will send the gerbers for a quote when i get home this evening.
Rhys
Rhys
samsagaz said:
No worries, Just to save myself any hassle i have to say, I will test all the joints but if there is an problem when it gets to you i cant be held responsible for your whole amplifier blowing up 😀
Im starting to get less amused about all these people wanting resistors soldering, after i realised the pcb's dont fit in the packaging any more. 😉
rhysh said:
I would also appreciate this, unless it is going to blow out your shipping cost's with the packaging. Then dont worry.
Thanks!
- Status
- Not open for further replies.