Hi. I am looking for some advice about wiring up a bluetooth module for use in a bluetooth speaker which I have built.
Looking at the diagram it appears as though the pus buttons are wired in series between the applicable pinout and the 1.8v pinout. The question I have is how do I get 3 or more wires connected to that 1 tiny 1.8v pin? Should I solder 1 piece of wire to it and then solder the the others to the end of it?
Here is a couple of images of the module:
https://www.google.co.uk/search?q=x...KHYFyAocQ_AUIBigB&dpr=1#imgrc=nzf3HYw_xAshHM:
Looking at the diagram it appears as though the pus buttons are wired in series between the applicable pinout and the 1.8v pinout. The question I have is how do I get 3 or more wires connected to that 1 tiny 1.8v pin? Should I solder 1 piece of wire to it and then solder the the others to the end of it?
Here is a couple of images of the module:
https://www.google.co.uk/search?q=x...KHYFyAocQ_AUIBigB&dpr=1#imgrc=nzf3HYw_xAshHM:
- Status
- Not open for further replies.